Question: How do you connect water lines under a sink?

How do you connect water pipes under sink?

1:542:54Installing Hot and Cold water lines to a sink - Technology Education LessonYouTubeStart of suggested clipEnd of suggested clipThe sink so youre going to have to reach behind the sink. Find that threaded pipe hanging down andMoreThe sink so youre going to have to reach behind the sink. Find that threaded pipe hanging down and thread on the supply. Line just and just make that hand tight.

How do you connect two water lines?

For flexible water supply lines, install your faucet and wrap the threaded end in several layers of Teflon Tape. Screw the threaded end and use a compression fitting to connect it to the walls supply line. For inflexible water supply lines like hard plastic or copper tubes, connect using compression fittings.

How do you install a faucet supply line?

0:041:33How to Replace a Faucet Water Supply Line: Install Fluidmasters YouTubeStart of suggested clipEnd of suggested clipTurn the nut counterclockwise. Until the threads align. Then turn the nut clockwise. And handMoreTurn the nut counterclockwise. Until the threads align. Then turn the nut clockwise. And hand tighten until you hear a click the click lets you know its sealed slowly turn the water supply valve.

What are the pipes under the kitchen sink called?

The U-shaped bend in your drain pipe is called the p-trap. This pipe is also referred to as a trap. However, the term trap can refer to a number of plumbing fixtures that serve similar purposes.

Can a wye be installed horizontally?

Yes. Ideally the inlet of a wye will be anywhere from right on top to 45 degrees to either side of the top. Given proper pitch, it can be rolled all the way down to 90 degrees from the top, but that is usually avoided.

Can you put a shower where a sink was?

Yes can do. Sounds like you MAY have a short distance to run from your proposed shower drain to the existing stack. If that is the case, please understand that it is not a big deal to have a 1.5 pipe run a short distance instead of a 2 pipe.

What is the extra hose under bathroom sink?

1 Answer. Its a tap into the drain.

How do you extend faucet water lines?

0:361:40How to extend a flex hose pipe for kitchen tap. - YouTubeYouTube

Do you need Teflon tape on sink supply lines?

You dont need to connect the faucets to the water supply lines if they have hot and cold lines. Teflon tape can be used to seal and lubricate threaded pipe joints.

What happens if you over tighten water supply line?

Screwing a supply line on too tight is one of the worst things you can do. Such overtightening will cause the metal threads inside of the line to become warped, making it much easier for water to slip past. It may also damage the rubber O-rings inside of the line.

Say hello

Find us at the office

Smithback- Wessman street no. 51, 93155 Port-au-Prince, Haiti

Give us a ring

Jamarquis Mascia
+57 761 823 495
Mon - Fri, 11:00-20:00

Join us